User Manual Q&AAnswer
Feb 11, 2025 - 10:53 PM
To clean the Bellini BDOM613DG Built-in Electric Oven, follow these steps:
1. Switch off the oven and allow it to cool down before cleaning.
2. For painted and plastic parts, use a clean cloth wrung out in hot soapy water. Do not use abrasive cleaners or wire/nylon cleaning pads.
3. For stainless steel parts, use a clean cloth wrung out in hot soapy water, and dry with a soft cloth. Stubborn marks can be removed using a stainless steel cleaner.
4. Enamel surfaces and parts can be cleaned with warm, soapy water and a clean cloth. For stubborn marks, use a mild cream cleaner or a soap-filled pad.
5. Glass parts, including the oven door glass, should be cleaned with a non-abrasive glass cleaner. Take care not to scratch the glass surface.
6. To remove the oven door for cleaning, open the door to the maximum angle and pull the buckle at the door hinge backward. Close the door to a 30° angle, hold the door on each side, lift up, and slowly pull the door out from the oven.
7. The inner door glass panel can be removed for cleaning. Open the door wide, push the clips on the left and right sides of the door bracket, and remove the plastic top cover. Hold the glass and slide it out along the door bracket. Make sure to replace the glass panel the right way up.
8. The shelf runners can be removed for thorough cleaning. Make sure they are cool to touch, then grasp the runners and slide them out of their hanging holes.
9. For the oven lamp, disconnect power from the mains outlet or switch off the circuit breaker. Unscrew the glass lamp cover by turning it counter-clockwise, replace the bulb with a new one of the same type (25-40W/220V-240V, T300°C halogen lamp), and xxxx the glass lamp cover back in place.
Remember to always refer to the user manual for specific instructions and safety precautions when cleaning your Bellini BDOM613DG Built-in Electric Oven.
Add New Comment