User Manual Q&AAnswer
Feb 11, 2025 - 10:51 PM
To install the GREE FLEXX24HP230V1AH&BH Electric Heater Kit, please follow the steps outlined in the instruction manual:
1. Prior to installation, make sure to disconnect all power to the unit.
2. Provide a means of strain relief and conductor protection at the supply wire entrance into the cabinet.
3. Use copper conductors only.
4. Follow the National Electric Code and other applicable codes during installation.
5. If the appliance is installed in an enclosed area such as a garage or utility room with any carbon monoxide producing appliance, ensure proper ventilation.
To repair the electric heater kit, follow these steps:
1. Remove the front panel and upper access panel from the air handler.
2. Disassemble the electrical box.
3. Remove the electrical box.
4. Disassemble the metal plate at the mounting hole of the electric heater.
5. Install the electric heater to the metal plate position which was disassembled in step 4. Note that there are two holes circled which are used to fasten the electric heater bracket during installation.
6. Install the breaker. Lift up the buckle first, hold the breaker bracket, and then put down the buckle to fix the breaker.
7. Connect the electric heater terminal.
8. After installation, refer to the schematic diagram provided in the manual.
9. Install the electrical box back to its original position.
10. Install the front panel and upper panel back to the air handler. The electric heater installation is now completed.
For any further assistance or detailed instructions, please refer to the GREE FLEXX24HP230V1AH&BH Electric Heater Kit Instruction Manual or contact the manufacturer's U.S. contact information provided in the manual.
Add New Comment