User Manual Q&AAnswer
Feb 11, 2025 - 10:42 PM
To change the cutter on the BOSCH GSC 18V-16 Cordless Cutter, follow these steps:
1. Remove the battery from the power tool before carrying out any work on it.
2. Loosen the fastening xxxx for the upper cutter using a suitable tool.
3. Remove the upper cutter from the power tool.
4. If necessary, loosen the set xxxx for the bottom cutter using a suitable tool.
5. Remove the bottom cutter from the power tool.
6. Turn or replace the cutters as needed. The upper and bottom cutters are identical and have four cutting edges each.
7. When installing the bottom cutter, make sure it fits against the set xxxx .
8. Tighten the fastening xxxx for the upper cutter and the set xxxx for the bottom cutter with a tightening torque of 3-4 Nm.
Note: The cutters should not be re-ground. Only sharp application tools achieve good cutting capacity and prolong the life of the power tool.
Please refer to the "Changing the cutter" section in the user manual for more detailed instructions and illustrations.
Add New Comment