User Manual Q&AAnswer
Feb 11, 2025 - 10:26 PM
To install the Interiors 1900 72982 Fenbridge 2 Wall Light, please follow these steps:
1. Ensure that the mains supply is switched off before starting the installation. It is recommended to withdraw the fuse or switch off the circuit breaker at the distribution board.
2. Decide on the position of the light fitting or remove the existing light fitting. Take note of the electrical connections and ensure there is a solid mounting surface, preferably a wooden joist or joist bridge, to support the weight of the light fitting. Be careful not to drill into any pipes or main cables during hole preparation.
3. Securely fix the product to the mounting surface using the screws and wall plugs provided. Note that the screws and wall plugs are suitable for masonry only. If you are installing on a different surface, you will need to purchase suitable fixings.
4. Make sure all electrical connections are tight and there are no loose strands left out of the terminal. Do not connect the Live or Neutral wires to Earth.
5. For bulb replacement, switch off the product and allow it to cool down before handling the bulb. Do not use liquid or abrasive cleaners to clean the product, only use a dry cloth.
6. If the bulb does not light up after installation, check for electricity failure and ensure all connections are secure.
If you have any doubts or concerns about the installation or use of this product, it is advisable to consult a qualified electrician.
Add New Comment