User Manual Q&AAnswer
Feb 11, 2025 - 09:37 PM
To connect the TOPDON ArtiLink 600 Diagnostic Scanner to your vehicle, follow these steps:
1. Start by locating the vehicle's DLC (Data Link Connector) port. This port is typically located under the dashboard on the driver's side.
2. Connect the Artilink600's OBDII cable to the vehicle's DLC port. The Artilink600 will power on automatically once connected.
3. Once the scanner is powered on, it will be ready to use for diagnostics.
Note: Make sure the ignition is turned on, the vehicle battery voltage is between 9 and 18 volts, and the throttle is in the closed position before starting the diagnostics.
For more detailed instructions and information, please refer to the TOPDON ArtiLink 600 Diagnostic Scanner User Guide.
Add New Comment