How do I install the HOLMAN CD1120C Retractable Hose Reel? (HOLMAN CD1120C Retractable Hose Reel User Guide)

Answer

manuals.plus

Feb 11, 2025 - 09:35 PM


To install the HOLMAN CD1120C Retractable Hose Reel, follow these steps:

1. Choose a location nearest to your water source for convenience.
2. Check if the tap-to-reel hose can reach your tap before installing the wall bracket.
3. Place the wall bracket against a wall or wooden post and mark the center of each bracket hole for drilling.
4. Drill four holes using the correct size drill bit for your hose reel. If using plugs not included with the reel, drill slightly undersize for a secure fit.
5. Hammer the wall plugs gently into the wall (if attaching to a wall).
6.  xxxx  in each hexagonal coach bolt until all four have a secure hold on the bracket against the surface.
7. Insert the mounting tube back into the holes on the wall bracket and housing, then replace the securing pin in the base of the mounting tube.
8. Take the hose reel and slot it over the wall bracket, aligning the holes in the housing with the holes in the wall bracket.
9. Connect your tap-to-reel hose to your garden tap.
10. Remove the securing pin at the base of the mounting tube to release the hose.

For more detailed instructions and illustrations, please refer to the HOLMAN CD1120C Retractable Hose Reel User Guide provided with the product.

Note: If you are unsure or need further assistance, it is recommended to contact HOLMAN customer service at 1300 716 188 or visit their website for additional support.