User Manual Q&AAnswer
Feb 11, 2025 - 08:56 PM
To install the THULE 186142 Integrated Railing-Flush Rails 4-Pack, please follow the provided installation instructions:
1. Start by identifying the correct position for the rails on your vehicle's roof. Ensure that the vehicle has integrated flush rails that are compatible with this product.
2. Clean the roof surface thoroughly to remove any dirt or debris that may affect the installation.
3. Take one of the rails and remove the end cap by sliding it off. Repeat this step for all four rails.
4. Place the rail onto the roof, aligning it with the integrated flush rails. Make sure it is positioned correctly and evenly on both sides of the vehicle.
5. Slide the rail forward or backward as needed to find the optimal position. The rail should be centered on the roof and parallel to the vehicle's body.
6. Once you have determined the correct position, tighten the clamping mechanism on the rail. Use the provided Allen key to secure the rail in place. Repeat this step for all four rails.
7. After tightening the clamping mechanism, replace the end caps on each rail by sliding them back into position.
8. Check the stability and alignment of the rails. Ensure that they are securely attached to the vehicle and do not move or wobble.
9. Repeat the installation process for the remaining rails, following the same steps.
10. Once all the rails are installed, double-check their tightness and alignment. Make any necessary adjustments to ensure a secure fit.
Please note that these instructions are a general guideline. It is essential to refer to the specific installation instructions provided in the THULE 186142 Integrated Railing-Flush Rails 4-Pack Instruction Manual for detailed and accurate installation steps.
Add New Comment