How do I connect the NETKRAFT 5163+4W282 Wireless Keyboard and Mouse Combo to my computer? (NETKRAFT 5163+4W282 Wireless Keyboard and Mouse User Manual)

Answer

manuals.plus

Feb 11, 2025 - 08:15 PM

To connect the NETKRAFT 5163+4W282 Wireless Keyboard and Mouse Combo to your computer, you need to follow these steps:

1. Install the batteries:
- For the mouse: Open the battery compartment located below the mouse, insert two AAA batteries, and close the compartment.
- For the keyboard: Open the battery compartment located below the keyboard, insert one AA battery, and close the compartment.

2. Connect the receiver:
- Plug the USB receiver into a direct USB port on your computer or use a USB extender if needed.

3. Pair the devices:
- Once the batteries are installed and the receiver is connected, the keyboard and mouse should automatically pair with the receiver. If not, follow the steps below.

Troubleshooting steps for pairing the mouse:
- Disconnect and reconnect the receiver to an available USB port on your computer.
- Place the mouse near the receiver (about 10 cm), remove the batteries, and then reinstall them.
- If the mouse turns on, it is ready for use.

4. Energy-saving features:
- The keyboard and mouse have energy-saving features to conserve battery power when not in use.
- Stand-by mode: If the devices are not used for 45 seconds, they will go into stand-by mode.
- Suspension mode: If the devices are not used for 15 minutes, they will go into suspension mode. Press any button to wake them up.

Please note that these instructions are based on the information provided in the NETKRAFT 5163+4W282 Wireless Keyboard and Mouse Combo user manual. For further assistance or troubleshooting, refer to the manual or contact the manufacturer's customer support.