User Manual Q&AAnswer
Feb 11, 2025 - 02:09 AM
To prepare the Udi RC UD1601 Breaker Drift Truck for use, follow these steps:
1. Charge the battery: Connect the included USB charger to the battery pack and plug it into a USB power source. The charging indicator on the charger will turn red, indicating that the battery is charging. Once fully charged, the indicator will turn green.
2. Install batteries in the remote control: Open the battery compartment on the remote control and insert four AA batteries (not included) according to the polarity markings. Close the compartment securely.
3. Turn on the truck and remote control: Turn on the power switch located on the truck's chassis. The LED indicator on the truck will light up. Then, turn on the power switch on the remote control. The LED indicator on the remote control will also light up.
4. Synchronize the remote control with the truck: Move the throttle stick on the remote control from the lowest position to the highest position and then back to the lowest position. This will synchronize the remote control with the truck. The LED indicator on the truck will flash rapidly when synchronization is successful.
5. Adjust trim settings: Use the trim buttons on the remote control to fine-tune the steering and throttle settings. Adjust the trim until the truck moves straight and the steering is centered when the control sticks are in the neutral position.
6. Test the functions: With the truck on a flat surface, test the steering, throttle, and other functions to ensure everything is working properly. Make any necessary adjustments to the trim settings if needed.
Please refer to the user guide provided with the Udi RC UD1601 Breaker Drift Truck for more detailed instructions and safety precautions.
Add New Comment