How do I install the Ihomeangel A04376 21 Inch Wide Black Vanity Light? (Ihomeangel A04376 21 Inch Vanity Light User Manual)

Answer

manuals.plus

Feb 11, 2025 - 02:07 AM

To install the Ihomeangel A04376 21 Inch Wide Black Vanity Light, please follow these steps:

1. Turn off the power: Before starting the installation, make sure to turn off the electricity. Go to the main fuse or circuit breaker box in your home and place the main power switch in the "OFF" position. Also, place the wall switch in the "OFF" position.

2. Prepare the tools: Before starting assembly and installation, make sure you have the necessary tools. The tools required for installation are not included with the product.

3. Check the parts: Carefully remove the fixture from the carton and check that all parts and accessories are included as shown in the illustration provided in the manual.

4. Make assembly:
- Step A1: Unscrew the xxxx nuts (F) from the backplate (E) and set them aside for later installation.
- Step A2: Pass the supply wires from the outlet box through the mounting plate (D). Secure the mounting plate (D) to the outlet box with the provided mounting screws (A).
- Step A3: Make wire connections by following the wire connection diagram provided in the manual. Twist the wires together with the plastic wire connectors (B) until tightly joined, and wrap each connector with approved electrical tape. Ensure that no wire strands are exposed and carefully tuck all wires into the outlet box.
- Step A4: Align the holes in the backplate (E) with the pre-assembled mounting screws and attach the backplate (E) to the mounting plate (D) using the previously removed xxxx nuts (F). Hand tighten until snug. If the backplate (E) is not snug against the wall, adjust the threaded length of the pre-assembled mounting screws on the mounting plate assembly (D) by unscrewing the pre-assembled hex nuts and then screwing the pre-assembled mounting screws in or out of the mounting plate (D) until the secure length is achieved. Tighten the pre-assembled hex nuts and proceed to Step A4.
- Step A5: xxxx the lampshades (I) onto the sockets (H). Install bulbs (not included) into the sockets. Make sure not to exceed the maximum wattage recommended on the socket.

5. Check the installation: Once everything is installed properly, you can turn on the light and enjoy it.

For any further assistance or inquiries, you can contact Ihomeangel customer care at +1 850 296 2377 or email them at homecustomercare@outlook.com.