User Manual Q&AAnswer
Feb 11, 2025 - 12:44 AM
To assemble the PROAIM P-SWCC-10 Sky-Walker Pro Cinema Cable cam System, follow these steps:
1. Start by loosening the bolts and sliding out the ends of the legs until they are fully opened. Then tighten the bolts again.
2. Repeat the same steps for the other side of the legs to assemble the Stand.
3. Next, insert the threaded Rod Axle into the Wire Spool Wheel.
4. Place the Wire Spool Wheel onto the Rope Stand and tighten the wing nuts on both sides for proper rope movement.
5. Now you can conveniently pull the rope for use.
For assembling the Chain Puller:
1. Press the lever to unlock the Ratchet lock and pull out the metal rope along with the pulley.
2. Insert the rope into the Pulley and attach the Climbing Hook.
3. Attach this pulley with the Climbing Hook on the same anchor, slightly above the Chain Pulley.
4. Insert the rope into the Cable Cam in the sequence of 1, 2, and 3.
5. Make a knot with the rest of the rope and fix the Climbing Hook with it.
6. Attach this Climbing Hook at a suitable location.
Note: The Main Drive Wheel and two Outer Wheels can be adjusted depending on the rope tension. It is important to adjust the hooks properly to ensure proper functioning.
There is an adjustment in the mounting of the Main Drive Wheel. You can shift its position depending on the rope tension.
For double safety of the Cable Cam:
1. Fix the Climbing Hook with the Safety Cable and attach it to either of the anchors.
2. Affix your Battery (not included) and connect it to the Cable Cam.
Please refer to the instruction manual for further details and illustrations on the assembly process.
Add New Comment