User Manual Q&AAnswer
Feb 10, 2025 - 11:43 PM
To install the nVent FBS12 Footed Box/Conduit Support, please follow the instructions provided in the product manual. Here is a step-by-step guide:
1. Determine the desired location for the support and mark the position on the floor or concrete form.
2. Drill a 3/16" hole at the marked location.
3. Insert the support into the hole, ensuring that it is securely seated.
4. Adjust the height of the support as needed by sliding it up or down.
5. Once the desired height is achieved, secure the support in place using the provided nVent CADDY fasteners.
6. Repeat the above steps for additional supports if required.
7. If supporting multiple raceways, you can combine the support with nVent CADDY strut or threaded rod to provide additional support.
8. Ensure that the support is properly aligned and securely fastened before proceeding with conduit installation or electrical box mounting.
For more detailed instructions and diagrams, please refer to the nVent FBS12 Footed Box/Conduit Support instruction manual available on the nVent website or contact your nVent customer service representative.
Remember to always follow the manufacturer's instructions and warnings to ensure proper installation and avoid any potential hazards or product malfunctions.
Add New Comment