User Manual Q&AAnswer
Feb 10, 2025 - 11:36 PM
To install the DHS AYBSZHD1305 Round Closed Front Toilet Seat, please follow the steps outlined in the installation guide provided with the product. Here is a step-by-step guide for your convenience:
1. Start by removing the old toilet seat, if there is one. To do this, locate the two plastic bolts on the underside of the toilet seat. Use a screwdriver to unscrew the nuts holding the bolts in place. Once the nuts are removed, lift the old seat off the toilet bowl and set it aside.
2. Before installing the new seat, clean the toilet bowl and the area around the mounting holes to ensure a clean surface for installation.
3. Take the new DHS AYBSZHD1305 Round Closed Front Toilet Seat and position it over the mounting holes on the toilet bowl. Make sure the seat is aligned properly and centered.
4. Insert the plastic bolts provided with the toilet seat into the mounting holes on the toilet bowl. The bolts should be inserted from the top side of the bowl, with the threaded end pointing down.
5. Once the bolts are inserted, secure them in place by tightening the nuts underneath the toilet bowl. Use a screwdriver to tighten the nuts until they are snug, but be careful not to overtighten as it may cause damage.
6. After securing the bolts, check the alignment of the seat again to ensure it is centered and level. Adjust the position if necessary.
7. Finally, test the seat by gently sitting on it to ensure it is securely installed and does not wobble. If needed, make any adjustments to the bolts or nuts to achieve a stable fit.
Please note that this is a general guide, and it is important to refer to the specific instructions provided in the DHS AYBSZHD1305 Round Closed Front Toilet Seat installation guide for accurate and detailed instructions.
Add New Comment