User Manual Q&AAnswer
Feb 10, 2025 - 11:04 PM
To install and use the energous VN-1820 WattUp WPT Charger with Stand, please follow the instructions below:
1. Professional Installation: The VN-1820 Charger requires professional installation. Ensure that it is installed correctly according to the provided instructions.
2. Placing the Stand: Place the stand on a flat surface.
3. Mounting the Device: Insert the mounting cleats into the corresponding holes in the back of the device. The device should only be used when correctly installed into the stand. Do not use the device without the stand.
4. Power Connection: Ensure that the power port is at the bottom of the device once mounted. Connect the Jack port cable end to the VN-1820 Charger and the AC power cable end to the wall outlet.
5. Standby Mode: When not charging, the VN-1820 is in standby mode.
6. Charging Process: Place the equipment to be charged in front of the VN-1820 charger. The equipment should commence charging within a few seconds. Refer to the user manual of the equipment being charged for the time duration and charging procedures.
Please note that the VN-1820 Charger can only be used with devices that contain the proprietary Energous energy receiving circuits. If a device does not have these circuits, charging will not occur. Additionally, the charger is intended for indoor use only and should not be used in wet areas, on metal surfaces, or outdoors.
For further information and detailed instructions, please refer to the User Manual and User Information provided with the product.
Add New Comment