User Manual Q&AAnswer
Feb 10, 2025 - 09:08 PM
To connect the Humminbird 532458-2 AIS to your Humminbird control head, you will need to follow the instructions provided in the installation guide. Here is a step-by-step guide:
1. Identify the Humminbird Port for AIS Connection: Locate the AIS-compatible port on your Humminbird control head. Refer to the illustrations in the guide to find the correct port.
2. DE-9 Connection: If your AIS data cable has a DE-9 connector, follow these steps:
a. Turn off the power for both the Humminbird control head and the AIS.
b. Connect the AS-PC2 NMEA-COM connector to the Humminbird COM port.
c. Connect the AS-PC2 cable's DE-9 connector (female) to the null modem.
d. Connect the AIS data cable's DE-9 connector to the null modem.
e. Refer to your AIS installation guide to complete the connection and power setup for the AIS equipment.
3. Bare Wire Connection: If your AIS data cable has bare wires for connection, follow these steps:
a. Turn off the power for both the Humminbird control head and the AIS.
b. Use your AIS installation guide to locate the transmit, receive, and ground wires on the AIS data cable.
c. Connect the AS-HHGPS wires to the AIS data cable wires as shown in the provided wiring chart.
d. Tape or apply heat-shrink insulation to each connection to prevent shorting the wiring.
e. Route the cable to the Humminbird control head.
f. Connect the AS-HHGPS NMEA-COM connector to the Humminbird COM port.
g. Refer to your AIS installation guide to complete the connection and power setup for the AIS equipment.
4. Set the Baud Rate: Configure the Humminbird control head and the AIS to communicate at the same baud rate. Follow the instructions in the guide to access the Setup menu on your control head and select the appropriate baud rate.
Please note that these instructions are a summary of the installation guide. For more detailed information and illustrations, refer to the complete installation guide provided by Humminbird.
Add New Comment