Answer

Feb 10, 2025 - 08:24 PM
To properly inflate the , follow these steps:
1. Remove all sharp objects from the surface to avoid damaging the SUP board.
2. Unscrew the valve cap and push the button in and turn it approximately 90 degrees to the "OUT" position.
3. Insert the pump hose end piece into the valve base and begin inflating the SUP board using the included hand pump.
4. Inflate the SUP board until you reach the required pressure. The correct pressure for this SUP board is a maximum of 1 bar / 15 PSI.
5. After inflation, tighten the valve cap clockwise to ensure air tightness.
6. To release air from the SUP board, remove the valve cap and push the button in and turn it approximately 90 degrees to the "IN" position.
Note: Do not exceed the maximum pressure of 1 bar / 15 PSI. Using an electrical pump or air compressor is at your own risk and can lead to damaging the SUP board.
Add New Comment