User Manual Q&AAnswer
Feb 10, 2025 - 11:19 AM
If your Pool Blaster is not sucking up water, there are a few possible reasons for this issue. First, make sure that the filter is properly attached and in good condition. Even if it appears to be clean, it may be clogged or damaged, preventing proper suction. Try replacing the filter with a new one to see if that resolves the problem.
Another possible cause could be a blockage in the vacuum's intake or hose. Check for any debris or obstructions that may be blocking the flow of water. Clear out any blockages and ensure that the hose is properly connected to the vacuum.
If the above steps do not solve the issue, it is possible that there may be a problem with the motor or other internal components of the vacuum. In this case, it is recommended to contact the manufacturer's customer support for further assistance or to inquire about warranty coverage.
Please note that the information provided here is a general troubleshooting guide and may not cover all possible causes for the issue. Refer to the Pool Blaster 10000AB Aqua Broom Cordless Vacuum User Manual for more detailed troubleshooting steps and contact the manufacturer for specific support.
Add New Comment