How do I sync the ThermoPro Humidity and Temperature Monitor remote sensor with the base station? (ThermoPro Humidity Temperature Monitor Instruction Manual)

Answer

manuals.plus

Feb 10, 2025 - 09:51 AM

To synchronize the remote sensor with the base station for the ThermoPro TP-63B/TP63C Humidity and Temperature Monitor, please follow these steps:

1. Bring the remote sensor near the base station.
2. Once the batteries are installed into the base station, the RF indicator on the base station will flash for 3 minutes, indicating that the base station is in synchronization mode and is waiting for remote sensors to be registered.
3. Set the CHANNEL selector on the back of the remote sensor unit to position 1 or 2 or 3. The unit is preset on Channel 1, and you can always leave it unchanged unless you have purchased more than 1 remote sensor.
4. Press and hold the ON/OFF button on the back of the remote sensor for 2 seconds to turn on the remote sensor. If done correctly, the temperature/humidity of the remote sensor will appear on the base station.
5. If the RF indicator on the base station no longer flashes and the remote sensor temperature is not displayed on the base station, press and hold the CHANNEL/SYNC button on the back of the base station for 3-4 seconds until the RF indicator flashes again to set it back in synchronization mode.
6. If you have additional remote sensors, repeat the above steps to synchronize the additional remote sensors. Please note that the additional sensors should be set to a different channel.
7. If you have registered more than one sensor, press the CHANNEL/SYNC button on the base station to select the remote channel you want to be displayed permanently on the base station. If you wish to cycle through all the channels, press the CHANNEL/SYNC button until you observe a circular arrow on the base station LCD display. The unit will auto-scroll, changing from channel to channel every 5 seconds. Press the CHANNEL button until you observe the circular arrow disappear, and the unit will stop cycling.

Please refer to the ThermoPro TP-63B/TP63C Humidity and Temperature Monitor Instruction Manual for more detailed information and illustrations.