User Manual Q&AAnswer
Feb 10, 2025 - 05:27 AM
To install the Avenli 29P41 Series Super Clean Filter Pump, please follow these steps:
1. Set up your pool and fill it with water according to the pool's installation instructions.
2. Remove the filter pump and hoses from the packaging.
3. Place the filter pump below the pool water, ensuring it is at least 0.2m and not over 1.0m below the water level.
4. Mount the filter pump on a solid and even ground using the mounting holes located in the pump base.
5. Insert the filter cartridge into the filter chamber and ensure it is properly seated.
6. Put the filter housing O-ring on the filter chamber.
7. Place the filter housing cover on the filter chamber.
8. Finger-tighten the filter chamber cover retainer in a clockwise motion.
9. Connect one filter hose to the inlet port of the filter pump (top) and the lower hose connection of the pool. Secure the hose with hose clamps.
10. Gently turn the air release valve in a counter-clockwise direction 1-2 turns.
11. Connect the second filter hose to the upper hose connection of the pool and the outlet port (bottom) of the filter pump. Secure the hose with hose clamps.
12. Ensure the pool is filled with water before operating the filter pump to avoid low water pressure and noisy motor sounds.
For a visual reference, please refer to the installation illustration on pages 6 and 7 of the user manual.
Add New Comment