User Manual Q&AAnswer
Feb 10, 2025 - 04:56 AM
To attach sandpaper to the BORMANN Bat2007 Vibration Pneumatic Sander, follow these steps:
1. Push down on the Clamp Lever to release the Paper Clamp.
2. Insert one end of the sandpaper under the Paper Clamp and snap it closed. Repeat the process with the rear Paper Clamp.
3. Check that the sandpaper fits snugly against the Sanding Pad. If not, repeat the process above and pull the sandpaper more tightly against the Sanding Pad.
4. Connect the sander to the air compressor.
5. Set the compressor to 90 PSI (do not exceed 100 PSI).
6. If applicable, secure your workpiece using appropriate clamping devices.
7. Before starting the sander, place it on the workpiece. If you start the sander before contacting the workpiece, it may vibrate out of your hand once you make contact.
8. To operate, press the Lever with the palm of your hand while using your fingers to grasp the sander. The further you press down on the Lever, the faster the sander will rotate. For fine-tuning the air pressure, adjust the Regulator xxxx .
9. Do not apply force or pressure. Allow the sander to do the work for you.
10. During operation, use your other hand to keep the air hose clear of the sander.
11. When finished, release the Lever and disconnect the air hose from the sander.
Please refer to the BORMANN Bat2007 Vibration Pneumatic Sander Owner's Manual for more detailed instructions and safety precautions.
Add New Comment