How do I install the StarTech ST1000SPEXD4 2 Port PCI Express Gigabit Ethernet Network Card? (StarTech ST1000SPEXD4 2 Port Gigabit Network Card User Guide)

Answer

manuals.plus

Feb 10, 2025 - 03:22 AM


To install the StarTech ST1000SPEXD4 2 Port PCI Express Gigabit Ethernet Network Card, follow these steps:

1. Turn off your computer and any peripheral devices connected to it.
2. Unplug the power cable from the back of your computer.
3. Disconnect any peripheral devices connected to your computer.
4. Remove the cover from your computer case. Refer to the documentation that came with your computer for instructions on how to do this safely.
5. Locate an open PCI Express slot and remove the corresponding slot cover plate from the back of your computer case. This card works in PCI Express x1, x4, x8, or x16 slots.
6. Gently insert the PCI Express card into the open slot and fasten the bracket to the back of the computer case.
7. Return the cover back onto your computer case.
8. Reconnect the power cable to the back of your computer.
9. Reconnect all the peripheral devices that were disconnected earlier.
10. Turn on your computer and peripheral devices.

For detailed instructions and illustrations, please refer to the "Install the PCI Express Card" section in the StarTech ST1000SPEXD4 2 Port PCI Express Gigabit Ethernet Network Card User Guide.

Note: Make sure to follow proper grounding procedures to prevent static electricity damage. It is recommended to wear an anti-static strap or discharge any built-up static electricity by touching a large grounded metal surface before handling the PCI Express card.