User Manual Q&AAnswer
Feb 10, 2025 - 02:41 AM
To calibrate the charging leads on the GYS GYSFLASH 10.36/48 PL battery charger, follow these steps:
1. Make sure the charger is disconnected from the mains socket.
2. Short-circuit the ends of the charging leads.
3. Press the buttons "+" and "-" simultaneously.
4. Plug in the mains plug while holding down the two buttons until the indicator light "+" or "-" lights up.
Results:
- If the indicator "+" is on, the calibration was successful.
- If the indicator "-" is on, the calibration failed. Disconnect the mains plug and restart the procedure.
Note: It is strongly recommended to perform this procedure each time the cables are modified or changed.
Please refer to the user manual for more detailed instructions and safety precautions.
Add New Comment