How do I install the Green Lighting Interiors 1900 69842 Winchester Swing Arm Wall Light? (My Green Lighting Interiors Swing Arm Wall Light Instruction Manual)

Answer

manuals.plus

Feb 10, 2025 - 02:23 AM

To install the Green Lighting Interiors 1900 69842 Winchester Swing Arm Wall Light, follow these steps:

1. Decide on the position of the light fitting or remove the existing light fitting. Ensure there is a solid mounting surface, preferably a wooden joist or joist bridge, to support the weight of the light fitting.

2. Take care not to drill into any pipes or mains cables beneath the surface during the preparation of mounting holes.

3. Switch off the mains supply before installation or maintenance. We recommend withdrawing the fuse or switching off the circuit breaker at the distribution board. Turning off the light switch is not sufficient.

4. The product must be securely fixed to the mounting surface using the screws and wall plugs supplied. Note that the screws and wall plugs are suitable for "masonry" only. Other fixings must be purchased separately.

5. Connect the house wiring to the terminal block provided. Ensure all electrical connections are tight and no loose strands are left out of the terminal.

6. Fit the shade (sold separately) by removing the retaining ring, placing the shade over the lampholder, and securing it with the retaining ring.

7. Fit the appropriate bulb (sold separately) according to the wattage specified on the label. Never use bulbs with a higher wattage than recommended.

8. Turn on the mains supply and test that the light illuminates.

Note: If you have any doubts about the installation or use of this product, it is recommended to consult a qualified electrician.

Please refer to the instruction manual for more detailed information and safety warnings.