User Manual Q&AAnswer
Feb 10, 2025 - 02:01 AM
To connect the 11n Mesh Card to the power supply, please follow these steps:
1. Connect the male header to the respective female header (J5) on the board. The red color wire (4V supply pin) should be connected to PIN 4 of J5, and the black color wire (ground pin) should be connected to PIN 6 of J5. Please note that the J5 header is present on the bottom side of the board.
2. Connect the two wires (red and black) from the Mesh Card's J5 connector using the male jumper to the power supply. The Mesh Card can be powered on using either a 12V or 4V supply. When the 11n Mesh Card is installed in the Vision Meter, it will be powered from a 4V supply.
Please refer to the "Mesh Card Power Supply Connection" section in the instruction manual for visual representations and additional details on connecting the power supply to the Mesh Card.
Add New Comment