User Manual Q&AAnswer
Feb 09, 2025 - 10:15 PM
To install the OSRAM H7-LED Head Light Car High Low Beams and LEDriving® ADAPTER, please follow the steps below:
1. Ensure that the vehicle's engine is turned off and the headlights are switched off before starting the installation process.
2. Locate the existing halogen headlight bulb on your vehicle. This is typically accessed from the rear of the headlight assembly.
3. Carefully remove the existing halogen bulb by disconnecting the electrical connector and releasing any retaining clips or screws.
4. Take the OSRAM H7-LED Head Light Car High Low Beams and LEDriving® ADAPTER out of the packaging. Ensure that all parts are included and undamaged.
5. Connect the LEDriving® ADAPTER to the OSRAM H7-LED Head Light Car High Low Beams. Ensure that the connection is secure.
6. Insert the OSRAM H7-LED Head Light Car High Low Beams into the headlight assembly, aligning the tabs or notches with the corresponding slots.
7. Secure the OSRAM H7-LED Head Light Car High Low Beams in place by reattaching any retaining clips or screws.
8. Connect the electrical connector from the LEDriving® ADAPTER to the vehicle's headlight wiring harness.
9. Double-check that all connections are secure and properly aligned.
10. Repeat the above steps for the other headlight if necessary.
11. Once the installation is complete, it is important to have the factory settings readjusted by a qualified workshop. This ensures proper alignment and functionality of the headlights.
If you have any further questions or encounter any technical issues during the installation process, please contact OSRAM customer service via automotive-service@osram.com for assistance.
Add New Comment