Answer

Feb 09, 2025 - 10:06 PM
To match and connect the wires of the CRUTCHFIELD 120702001 Receiver Wiring Adaptor, follow these steps:
1. Match wires: Compare the wires of the adaptor to the wires on your receiver. The wire colors may or may not match, so it is important to match the wires by their function rather than color. Refer to the instructions supplied with your receiver to determine the function of each wire.
2. Tape off unused wires: If there are any wires on the adaptor that are not necessary for your specific receiver, individually tape them off to prevent any accidental connections.
3. Crimp connections: Strip back approximately 1/2" of insulation from the ends of the wires. Twist the corresponding wires from the adaptor and receiver together, and insert them into a crimp cap. Squeeze the middle of the cap to create a tight connection. Repeat this process for all necessary wires.
4. Electrical tape: If there are any wires from the Wiring Adaptor that do not have a match from your new receiver, wrap them with electrical tape to ensure they do not come into contact with any other wires or metal surfaces.
5. Application: Once you have completed the wiring connections, you can proceed to install the receiver. Plug the Wiring Adaptor from the new receiver or receiver assembly into the factory radio harness(es) in the vehicle dash.
Please note that these instructions are a general guideline, and it is important to refer to the specific instructions provided with your receiver for accurate and detailed wiring information.
Add New Comment