User Manual Q&AAnswer
Feb 09, 2025 - 09:50 PM
To calibrate the brake light on the SIGMA RL 150 Flashing Rear Light, follow these steps:
1. Make sure the light is turned off and not connected to any power source.
2. Press and hold the power button for 5 seconds until the light turns on.
3. After the light turns on, release the power button and wait for the light to enter calibration mode.
4. In calibration mode, the light will flash rapidly for a few seconds.
5. During this time, perform a hard brake on your bicycle to simulate a sudden stop.
6. The light will detect the change in motion and adjust the brake light accordingly.
7. Once the calibration process is complete, the light will return to its normal operation mode.
Note: It is important to perform the calibration process in a safe environment, away from traffic or any potential hazards.
Add New Comment