Answer

Feb 09, 2025 - 09:48 PM
Loading staples into the SENCO F75LXP Crown Long Reach Anvil Clinching Stapler is a straightforward process. Here are the steps to follow:
1. Ensure that the stapler is disconnected from any power source or air supply before attempting to load staples.
2. Locate the magazine release lever on the rear of the stapler. Push the lever down to release the magazine.
3. Slide the magazine out from the stapler body.
4. Open the magazine by pulling the latch located at the bottom of the magazine towards you.
5. Insert a strip of staples into the magazine, ensuring that the staples are facing downwards and the legs of the staples are aligned with the grooves in the magazine.
6. Close the magazine by pushing the latch back into place until it clicks.
7. Slide the magazine back into the stapler body until it locks into place. Ensure that the magazine release lever pops back up, indicating that the magazine is securely inserted.
8. Test the stapler by pressing the trigger or actuating the firing mechanism according to the instructions in the user manual.
Please refer to the SENCO F75LXP Crown Long Reach Anvil Clinching Stapler User Guide for more detailed instructions and safety precautions.
Add New Comment