User Manual Q&AAnswer
Feb 09, 2025 - 08:16 PM
To install the casters on the UPLIFT DESK STR041 3-Drawer Narrow Square File Cabinet, follow these steps:
1. After unboxing the File Cabinet, unlock the drawers and remove the casters, Pencil Tray, and hardware from the top drawers.
2. Turn the File Cabinet upside down on a clean blanket or carpet to protect the top surface from scratches. Be careful to keep the drawers from opening while turning the File Cabinet over.
3. Pull out the bottom drawer, exposing the top and bottom sides of the caster mounting holes located at the 4 corners of the bottom surface.
4. Put a Split Lock Washer on the stem of a Front Locking Caster and place the stem through one of the front holes.
5. From the inside of the bottom surface, thread a Flange Lock Nut onto the Front Locking Caster stem. Use one 14 mm Flat Wrench to hold the integrated caster nut and tighten the Flange Lock Nut with the other 14 mm Flat Wrench.
6. Repeat steps 4 and 5 for the remaining casters, making sure the other Front Locking Caster is installed in the other hole at the front of the File Cabinet, and the 2 Rear Casters (non-locking) are installed in the back.
Please refer to the instruction manual for visual illustrations and additional information on the installation process.
Add New Comment