User Manual Q&AAnswer
Feb 08, 2025 - 05:32 AM
To install the flashlight onto the PTX tool in the JONARD TOOLS PTX-FLA Universal Flashlight Kit, please follow these steps:
1. Loosen the housing nut: Start by loosening the housing nut on the flashlight unit. This will allow you to slide the unit onto the PTX tool.
2. Slide unit onto the PTX tool: Once the housing nut is loosened, slide the flashlight unit onto the PTX tool. Make sure it fits securely.
3. Tighten the housing nut: Once the flashlight unit is properly positioned on the PTX tool, tighten the housing nut securely. This will ensure that the flashlight stays in place during use.
Note: The flashlight in this kit uses a AA battery, which can be easily replaced by unscrewing the end cap. This allows for convenient battery replacement whenever needed.
If you have any further questions or need additional assistance, please refer to the JONARD TOOLS PTX-FLA Universal Flashlight Kit Instruction Manual or contact JONARD TOOLS directly at Tel 914.793.0700 or Fax 914.793.4527.
Add New Comment