User Manual Q&AAnswer
Feb 08, 2025 - 04:06 AM
To install the Enduro 27-9013 Sherco Ignition Wire Guard, please follow these steps:
1. Using an 8mm T-Handle or Socket, remove the two bolts shown in FIG 1. Take note of which bolt goes where, as the further forward bolt is slightly longer.
2. Line up the Enduro Engineering Ignition Wire Guard to the two bolt holes you removed in step 1. Use the same bolts removed in step 1 and thread them in one at a time. Leave them loose until both bolts are started, as shown in FIG 2.
3. Using an 8mm T-Handle or Socket, tighten both Ignition Wire Guard bolts securely, as shown in FIG 3.
4. Once installed, you can now enjoy your next ride with the added protection provided by the Ignition Wire Guard.
Please note that it is recommended to have the Enduro 27-9013 Sherco Ignition Wire Guard installed by a licensed motorcycle dealer or technician. Motorcycles can be dangerous, and improper installation or misuse of aftermarket parts can increase the risk of serious injury, death, or property damage.
Additionally, please be aware of the warning and disclaimer provided by Enduro Engineering, Inc. (EEI) in the manual. EEI's customers are responsible for exercising good judgment in the use, control, alteration, part selection, installation, and maintenance of their motorcycles. Any claims or issues related to a part manufactured, designed, or sold by EEI must be brought within one year of purchase, and the claim must be brought in the Michigan State Courts or the Federal District Court for the Western District of Michigan, with Michigan law applying.
For further information or assistance, you can contact Enduro Engineering at enduroeng.com or call 517.393.2421, or email info@enduroeng.com.
Add New Comment