User Manual Q&AAnswer
Feb 08, 2025 - 03:03 AM
To install the remote control for the BIDET UX Pearl, you have two options.
Option A: Remote Control Wall Mount Installation
1. Choose a location for the remote control wall mount and mark the two mounting holes.
2. Drill holes with a 6mm drill bit, with a depth of 35mm if using anchors.
3. Insert the anchors into the drilled holes.
4. Place the wall mount over the anchors and tighten the screws. You can cover the screws with the included silicone gaskets.
5. Remove the battery door cover on the remote control and insert two A batteries.
6. Place the remote control into the wall mount (magnetic).
Option B: Remote Control Wall Mount Installation (Tape)
1. Clean and dry the area where you want to install the wall mount.
2. Remove the adhesive tape cover on the back of the wall mount and press it firmly against the wall. Hold for 5-10 seconds.
3. The mounting holes can be covered with the included silicone gaskets.
4. Remove the battery door cover on the remote control and insert two A batteries.
5. Place the remote control into the wall mount (magnetic).
Please note that the remote control should be installed within range of the BIDET UX Pearl for proper functionality.
For more detailed instructions and illustrations, please refer to the "Remote Control Installation" section in the BIDET UX Pearl Remote Control User Manual.
Add New Comment