User Manual Q&AAnswer
Feb 08, 2025 - 02:55 AM
To install the ZWAVE 0-200W Smart LED Dimmer, please follow these steps:
Step 1: Remove the xxxx and the cover plate.
Step 2: Make sure the electricity is switched off during installation. Then connect the wires as indicated in the 'Connection diagram' provided in the manual.
Step 3: Install the dimmer in the mounting box using screws or by tightening the screws of the mounting clamps.
Step 4: Switch the electricity back on and press the dimmer shaft to turn on the connected lights. Adjust the 'MIN/MAX adjustment' as described under 'MIN/MAX installation' in the manual.
Step 5: Optionally, you can connect the dimmer to your SMART home system as indicated under the heading 'Connecting home automation / apps'.
Step 6: Place back the cover plate and dimmer xxxx .
Please note that it is important to read the instructions carefully and ensure proper wiring and installation to avoid any damage to the dimmer.
Add New Comment