User Manual Q&AAnswer
Feb 08, 2025 - 02:50 AM
Sure! Here are the step-by-step instructions for installing the SOtM SCLK-EX Board:
1. Power off your PC and disconnect the AC power cable.
2. Open the PC case and locate an available 3.5" bay bracket inside the case.
3. Install the SCLK-EX Board using the supplied 3.5" bay bracket. Secure it in place.
4. Connect the PC's SATA power cable to the supplied SATA power PCB.
5. Connect the SATA power PCB to the SCLK-EX Board using the supplied SCLK-EX DC power cable.
6. If applicable, connect the clock connect PCB on the SCLK-EX Board to the corresponding clock output on your other board using the supplied RF cable.
7. Refer to the installation guide/manual of the other board (e.g., tX-USBexp, sNI-1G) and install it into the PC following the provided instructions.
8. Power on your PC and install the necessary drivers for the connected board (e.g., tX-USBexp driver).
Please note that these instructions are general guidelines, and it's important to refer to the specific installation guide/manual provided with your purchased package for detailed instructions. Additionally, if you are not proficient in soldering or unsure about any step, it is recommended to seek assistance from SOtM or the seller to ensure proper installation and avoid any damage or malfunction.
Add New Comment