User Manual Q&AAnswer
Feb 08, 2025 - 02:46 AM
To connect the gas cylinder to the KEMPER GROUP 104980 Gas Cooker, please follow these steps:
1. Ensure that all operations are performed in properly ventilated places, at a proper distance from free flames or flammable materials.
2. Only use gas cylinders in compliance with TPED standard and further regulations enforced in the country where the appliance is used.
3. Connect the stove to the cylinder using a rubber pipe for LPG gas, in compliance with standards enforced in the country where the appliance is used.
4. Ensure that the pipe is not twisted.
5. Install the hose by passing it at the side of the stove, keeping it away from the cooking area to avoid dangerous overheating of the gas pipe.
6. The pipe length must not exceed 1.5 meters and must always be in good condition. If the pipe needs to be replaced, refer to the standard enforced in the country where the appliance is used and its expiry date (if any).
7. Always use a low-pressure regulator to connect the stove to the cylinder. This regulator must have a fixed calibration normalized at 30 mbar for butane and 37 mbar for propane.
8. In countries where the user can fasten the pipe to both the stove and regulator, use full-mesh metal bands suitable for LPG gas pipe.
9. Never search for leaks by free flames, only use a proper spray containing soapy water.
10. Never use the appliance with rubber pipes that do not comply with standards or are not firmly fastened to full-mesh metal bands.
11. Place the stove away from flammable substances or heat-sensitive objects.
12. Check that the stove valves are closed.
13. Fully open the cylinder valve.
14. Press and rotate clockwise the valve corresponding to the cooking ring to be switched on to the maximum position.
15. Put the flame close to the cooking ring to switch it on.
16. Adjust the flame according to your needs.
Please refer to the instruction manual for more detailed information and safety precautions.
Add New Comment