User Manual Q&AAnswer
Feb 08, 2025 - 01:40 AM
To set the net address and on-off settings on the frigicoll FRIMB-FA2 Console Multifunction Board, you can refer to the following instructions:
1. Net Address Setting:
- Locate the rotary switch ENC3 and dip-switch F1 on the multifunction board.
- The rotary switch ENC3 is used for net address setting.
- Refer to the provided scheme in the manual to determine the appropriate net address setting for your specific configuration.
2. On-Off Setting:
- Locate dip-switch F2 on the multifunction board.
- Dip-switch F2 is used for on-off setting.
- The dip-switch has two positions: ON and OFF.
- By connecting the ON-OFF port, an 'OFF' signal is sent to switch off the unit. You can switch on the unit with the remote controller.
- By disconnecting the ON-OFF port, an 'ON' signal is sent to switch on the unit. You can switch off the unit with the remote controller.
Please note that the specific steps and configurations may vary depending on your specific model and setup. It is recommended to refer to the owner's manual provided with your frigicoll FRIMB-FA2 Console Multifunction Board for detailed instructions and illustrations.
Add New Comment