How do I install the Halco FM-DR12-16-CS ProLED Select Flush Mount Double Ring fixture? (Halco FM-DR12-16-CS Flush Mount Double Ring Instruction Manual)

Answer

manuals.plus

Feb 07, 2025 - 10:18 PM


To install the Halco FM-DR12-16-CS ProLED Select Flush Mount Double Ring fixture, follow these steps:

1. Before starting the installation, make sure to disconnect the power by turning off the circuit breaker or removing the fuse at the fuse box.

2. Prepare the fixture by unscrewing the caps and removing the cover (B) and ring (C) from the base board (A).

3. Prepare the mounting bracket (AA) by aligning two of the threaded holes on the bracket over one set of keyhole slots on the base board (A).

4. From the front side of the base board (A), insert the 30mm screws (CC) and ground  xxxx  (EE) into the aligned holes, leaving approximately 1 inch of space between the  xxxx  heads and mounting bracket (AA).

5. Attach the mounting bracket (AA) to the outlet box using the 25mm screws (DD).

6. Connect the copper wire on the base board (A) to the mounting bracket (AA) by securing it with the ground  xxxx  (EE).

7. Use a wire connector (BB) to connect the ground wire from the base board (A) to the ground wire from the outlet box.

8. Use a wire connector (BB) to connect the white wire from the base board (A) to the white wire (Neutral wire) from the outlet box.

9. Use a wire connector (BB) to connect the black wire from the base board (A) to the black wire (Live wire) from the outlet box.

10. Wrap the three wire connections with electrical tape for a more secure connection and position the wires inside the outlet box.

11. Align the channels on the fixture with the screws (CC) protruding from the mounting bracket. Slide the base board until it clicks into place over the screws (CC). Tighten the screws (CC) to secure the base board (A) in place.

12. Switch to your desired CCT (Correlated Color Temperature). Attach the cover (B) and ring (C) to the base board (A) by screwing them up.

Please note that these instructions are a summary and should be followed in conjunction with the complete instruction manual provided with the product. Ensure that the installation is done by a qualified electrician in accordance with the National Electrical Code and local codes. Always prioritize safety and consult a professional if needed.