User Manual Q&AAnswer
Feb 07, 2025 - 10:11 PM
To install the HIFONICS EB-MIC Wireless Microphone Upgrade Kit in your HiFonics EB112A sound system, please follow the steps below:
1. Make sure the EB112A sound system is switched off and disconnected from the power supply.
2. Carefully remove the green circuit board from the microphone bag.
3. Remove the right carrying handle of the sound system using a suitable screwdriver.
4. Position one of the plastic washers on the inner baffle above the horn's magnet.
5. xxxx the circuit board and washer to the baffle, making sure not to overtighten the screws.
6. Align the circuit board and secure it with the second xxxx and washer.
7. Insert the connector located inside the housing on the circuit board. The two loose cable ends are the antennas for wireless reception. These should be placed loosely in the housing without any further fastening.
8. Attach the handle back to the housing.
9. Once the upgrade kit is installed, turn on the sound system.
If you encounter any difficulties during the installation process, it is recommended to contact a trained and technically skilled specialist or reach out to the Audio Design Service Department for assistance. They can be contacted at Tel. +49 7253 - 94 65 92 or via email at amplifiers@audio-design.de.
Please note that this upgrade kit is specifically designed for the HiFonics EB112A sound system and may not be compatible with other HiFonics EB models.
Add New Comment