User Manual Q&AAnswer
Feb 07, 2025 - 10:04 PM
To install the KSR LIGHTING KSRSF337 Multi Wattage Triple CCT Bulkhead, please follow the steps below:
1. Isolate the mains supply before installation.
2. Unscrew and retain the four screws and remove the diffuser.
3. Loosen the single LED tray xxxx as indicated and lift the hinged tray to gain access to the wiring terminals. Pass the intended supply wires through the grommet.
4. Ensure the fixing surface is flat and even.
5. Fix the base to the wall, ceiling, or besa box using adequate fixings suitable for the type of surface.
6. Ensure incoming cables are protected.
7. Terminate the wiring as per the instructions, noting that an Earth terminal is only supplied to aid the continuation of the Earth circuit.
8. Connect the battery, which can be accessed as shown in the manual.
9. Select the LED color and wattage required using the switches on the LED driver. Note: Never change the LED color or wattage with the luminaire powered on as this can damage the luminaire.
10. Set the Photocell by adjusting the Lux level required via the adjuster (anti-clockwise = lowest, clockwise = highest). To test, simply cover the photocell when powered on in daylight and wait for the luminaire to light up.
11. Re-secure the LED tray.
12. Ensure the seal is in place in the diffuser and undamaged.
13. Replace the diffuser and re-secure using the four retained screws.
14. Turn on the mains supply and test the luminaire. If using an optional rim clip, attach it over the fitting.
Please note that it is recommended to have the installation carried out by a qualified electrician to ensure compliance with current IEE wiring regulations and local building control.
Add New Comment