User Manual Q&AAnswer
Feb 07, 2025 - 09:23 PM
To properly install the , follow these steps:
1. Safety Precautions:
- Before starting the installation, make sure to disconnect power at the source by shutting off the circuit breaker or fuse.
- If you are unsure about the installation or maintenance of the wall light, it is recommended to consult an electrician.
- Use only copper or copper-clad wire for the installation.
2. Removing Existing Fixture (if applicable):
- If you are replacing an existing fixture, remove and disconnect the old fixture first.
3. Separate Feed and/or Switched Outlet Configuration (if applicable):
- If you need to wire the switch for separate feed and/or switched outlet configuration, remove the break-off fin located between the dark-colored screws before wiring. Use a Flat Head screwdriver to bend the fin until it breaks off.
4. Wiring the Switch:
- Remove insulation from the wires, leaving approximately 3/8" to 5/8" exposed.
- The HOT terminals on the switch have dark-colored screws. Loop each wire around its respective terminal xxxx according to the provided diagram.
- Fasten the screws securely. The terminal screws accept up to #12AWG copper or copper-clad wire.
5. Mounting the Switch:
- Use the long mounting screws provided to mount the switch to the desired location.
- Attach the wall plate to complete the installation.
6. Power Restoration:
- After completing the installation, restore power at the circuit breaker or fuse.
For any further assistance or clarification, you can contact Maxxima's customer support:
- Email: info@maxximastyle.com
- Phone: 866-MAXXIMA (629-9462)
- Website: www.maximastyle.com
Please note that the provided information is a general guide, and it is always recommended to refer to the official installation manual for specific instructions and safety guidelines.
Add New Comment