User Manual Q&AAnswer
Feb 07, 2025 - 08:55 PM
To install the door panel on the FISHER PAYKEL ADDD60D Integrated Single DishDrawer Dishwasher, follow these steps:
1. Remove both side pins with pliers and carefully pull the panel bracket down and out slightly.
2. Unplug the knock-to-pause module from the controller and remove the earth wire from the bracket.
3. Remove the Knock-to-Pause module from the back of the bracket.
4. Install the handle to the panel following the installation guidance available for your handle kit.
5. Attach the Knock-to-Pause module to the panel, ensuring it is correctly oriented and not in contact with the brackets before securing.
6. Reconnect the Knock-to-Pause module to the UI 1 slot on the wash controller.
7. Reconnect the Earth wire to the panel bracket. Note: Failure to reconnect the Earth wire may result in electrical shock or death.
8. Carefully fit the panels onto the product, ensuring they are aligned properly. Re-insert both side pins to secure the panels in place.
9. Insert a crosshead driver into the hole above each side pin and rotate to adjust the panel alignment. There is a maximum travel distance of ± 1/16”(2mm). Repeat for both sides if required.
Please refer to the FISHER PAYKEL ADDD60D Integrated Single DishDrawer Dishwasher Installation Guide for more detailed instructions and illustrations.
Add New Comment