User Manual Q&AAnswer
Feb 07, 2025 - 08:37 PM
To install the strands 270716 Hi-LO Snow Plow Driving Light LED, please follow the instructions provided in the user manual. Here is a step-by-step guide:
1. Before installation, make sure to read all instructions and study the diagrams provided in the manual.
2. Check with state or local authorities to ensure compliance with laws governing the usage and proper mounting of the lights.
3. Take care of the product by keeping it clean. Use lukewarm water and alkaline degreasing to clean the lens and heat-sink. Follow the degreasing instructions carefully and rinse off gently with cold or lukewarm water on low pressure.
4. Avoid using strong chemicals on the product, as they may damage the sealing adhesives and compromise the product's waterproofness. Rinse off immediately if strong chemicals come into contact with the product.
5. During installation, do not cut the contact/connector on the product, as it will void the warranty. If the product has loose cables without a connector, do not cut the cable if it is shorter than 50 cm. If the cable is longer than 50 cm, it is permissible to shorten it, but not shorter than 50 cm.
6. Ensure that screws and bolts are tightened properly to prevent loosening or chafing. However, do not overtighten screws to the point where the protective bearings on the product break.
7. It is important not to use higher volts than what is stated in the product description. Continuous use of the light may cause it to become hot, so avoid removing or touching the casing for at least 30 minutes after turning off the lamp.
Please refer to the user manual for any additional information or specific instructions related to the strands 270716 Hi-LO Snow Plow Driving Light LED.
Add New Comment