User Manual Q&AAnswer
Feb 07, 2025 - 05:25 AM
Installation:
1. Choose a suitable location for the LED Solar Groundspot where it will receive direct sunlight during the day.
2. Ensure the ground is level and free from any obstructions.
3. Remove the protective film from the solar panel.
4. Insert the ground spike into the ground, ensuring it is stable and secure.
5. Attach the LED Solar Groundspot to the ground spike by aligning the slots and sliding it downwards until it clicks into place.
Usage:
1. During the day, the solar panel will charge the built-in battery. Make sure the solar panel is exposed to direct sunlight.
2. At night, the LED Solar Groundspot will automatically turn on when it detects low light conditions.
3. To manually switch the light on or off, press the power button located on the underside of the fixture.
4. The LED Solar Groundspot has a built-in twilight sensor, which means it will only activate when it is dark enough.
5. If the light output decreases over time, it may be necessary to clean the solar panel to ensure optimal charging efficiency.
Safety Precautions:
1. This fixture is suitable for outdoor installation and is dust tight. It is also protected against water immersion up to 1 meter for 30 minutes.
2. The LED Solar Groundspot is designed for low voltage use only.
3. If the safety glass is broken, it must be replaced immediately to prevent any potential hazards.
Please refer to the smartwares 10.009.61 5000.197 LED Solar Groundspot Instruction Manual for more detailed information and troubleshooting tips.
Add New Comment