User Manual Q&AAnswer
Feb 07, 2025 - 04:58 AM
To set the zero position and control the displacement using the COREMORROW Piezo Controller Software, follow these steps:
1. Open the software and go to the Home Screen.
2. Select the desired channel (CH1, CH2, etc.) for which you want to set the zero position and control the displacement.
3. To set the zero position, click on the "Zero" button. This will send a "0" command to the piezo controller and set the slider control to "0".
4. To control the displacement, use the "+" and "-" buttons. "+" means increasing the current position by the step data, while "-" means decreasing the current position by the step data.
5. Make sure to pay attention to the direction of displacement ("+" or "-") and adjust it accordingly.
6. If the output exceeds the range during single point sending or step control, a prompt will appear and the output will not be sent.
Note: The specific steps may vary depending on the model of the piezo controller (E70 series, E53.C series, etc.). Refer to the user manual for your specific model for detailed instructions.
Add New Comment