User Manual Q&AAnswer
Feb 07, 2025 - 04:57 AM
To connect the E70.D4S Piezo Controller to your computer for control, you have two options: RS-232/422 and USB.
1. RS-232/422: Set the DIP switch or software to select the control mode. Connect the computer to the controller interface module through the RS-232/422 port access terminal. This will allow you to realize computer control of the controller.
2. USB: Set the DIP switch or software to select the control mode. Connect the computer to the controller interface module through the USB port access terminal. This will also allow you to realize computer control of the controller.
Please refer to the "Front Panel" section of the user manual for more details on the pin definitions and connections for RS-232/422 and USB.
Note: It is important to follow the instructions in the manual and ensure that the power is disconnected before making any cable connections.
Add New Comment