User Manual Q&AAnswer
Feb 07, 2025 - 04:38 AM
Sure! Here are step-by-step instructions on how to replace the blades on the SharkBite 25882 Pro-Grade Pipe Cutter, as outlined in the instruction manual:
1. Close the pipe cutter and secure it with the closing latch.
2. Using a 3/32" hex key (Allen wrench), remove the two blade screws. These screws can be found on the side of the pipe cutter. Refer to Figure 1 in the manual for visual guidance.
3. Open the pipe cutter to expose the blade.
4. Carefully remove the old blade and replace it with a new one. Make sure the new blade is aligned properly.
5. Close the pipe cutter and secure it with the closing latch.
6. Align the blade holes with the xxxx holes on the pipe cutter.
7. Using the hex key, replace the screws and tighten them securely.
Please note that the blades are sharp, so exercise caution when handling them. It is also important to keep the pipe cutter out of reach of children to prevent any potential injuries.
Add New Comment