User Manual Q&AAnswer
Feb 07, 2025 - 04:34 AM
To properly install the KODLin Lowering or Lift Kit for Harley Davidson Sportster S Models, follow these steps:
1. Securely raise the motorcycle at the rear section of the frame and jack it up enough that the rear wheel is slightly off the ground.
2. To disconnect the brake cable support, remove the M6 Allen xxxx .
3. Remove two M12 Hex Bolts and the stock damping rod. Repeat this step for the other side.
4. Install the KODLin Lowering or Lift Kit rod using two M12 Hex Bolts tightened to 62 ft/lbs. (85 Nm). Make sure to use medium strength thread locker, such as blue Loctite®, on all stock bolts.
5. Repeat the installation process for the other side.
6. Re-connect the brake line and tighten the M6 Allen xxxx .
7. Before going on a test ride, check that all hardware is securely tightened.
8. It is important to note that proper maintenance and inspection are required, and it is the installer's responsibility to ensure that all fasteners are tightened before operating the motorcycle. We recommend following the manufacturer's torque specifications and checking the belt tension for proper tension.
9. For additional technical tips and updated installation instructions, you can visit www.kodlinusa.com.
Please remember that improper installation or lack of maintenance may void any warranty coverage provided by Kodlin.
Add New Comment