Answer

Feb 07, 2025 - 04:18 AM
To install the Hunter 19973, 19974 Chevron light fixture, follow these steps:
1. Disconnect the power by turning off the circuit breakers to the outlet box associated with the wall switch location to avoid electrical shock.
2. Ensure that the installation site has a ground wire. If not, consult a qualified electrician before proceeding.
3. Familiarize yourself with national and local electrical codes ANSI/NFPA 70 and consult a qualified electrician if you are unsure about wiring.
4. Gather the necessary tools: ladder, screwdriver, pliers, and wire strippers.
5. Remove all contents from the carton and shut off the power at the circuit breaker.
6. Completely remove the old fixture from the ceiling, including the old mounting bracket.
7. Take out the new mounting bracket assembly from the bag and remove the cap nuts from the mounting screws.
8. Place the mounting plate over the junction box, ensuring that the mounting screws and nuts extend away from the ceiling.
9. Adjust the position of the mounting screws so that they can be exposed 5-6 mm after passing through the canopy.
10. Tighten the nuts on the mounting screws under the mounting plate to secure them in place.
11. Pull the house wires through the center of the mounting plate and secure the plate to the junction box by tightening the screws.
12. Assemble the fixture by determining the correct number of rods needed for hanging height. Use additional rods to lengthen the fixture or trim the wires to shorten it.
13. Thread the wires through the rods and pull them taut before connecting the rods together. xxxx the rod onto the post on the fixture.
14. Install the glass pieces inside the frame, ensuring the bottom edge rests in the channel and the top is securely locked with the bendable tabs.
15. Pull the fixture wires through the top of the canopy and xxxx the top rod to hang straight from the canopy.
16. Connect the fixture's wires to the power supply wires from the junction box: black to black, white to white, and grounding to grounding.
17. Twist the wire pairs together and secure with a wire connector.
18. Loop the fixture's ground wire around the grounding xxxx and tighten. If there is no ground wire from the junction box, consult a qualified electrician.
19. Raise the canopy to the mounting plate and secure it in place with cap nuts.
20. Install a light bulb according to the fixture's specifications, ensuring not to exceed the recommended wattage.
21. Turn on the power and test the fixture.
For more detailed instructions and safety precautions, refer to the Hunter 19973, 19974 Chevron Owner's Manual.
Add New Comment