Answer

Feb 07, 2025 - 03:23 AM
To connect the MARSON MT1 2D Scan Engine to your host system, you have two interface options: UART and USB.
For the UART interface, you will need to connect the following pins:
- UART_TX: Connect this pin to the UART data input of your host system.
- UART_RX: Connect this pin to the UART data output of your host system.
- GND: Connect this pin to the ground of your host system.
- VCC: Connect this pin to the 3.3V power supply of your host system.
For the USB interface, you will need to connect the following pins:
- USB_D+: Connect this pin to the USB D+ signal of your host system.
- USB_D-: Connect this pin to the USB D- signal of your host system.
- GND: Connect this pin to the ground of your host system.
- VCC: Connect this pin to the 3.3V power supply of your host system.
Please refer to the pin assignment diagram in the user guide for the exact pin locations on the MT1 scan engine. Make sure to follow the correct pin connections and ensure proper power supply to the scan engine.
Add New Comment