User Manual Q&AAnswer
Feb 07, 2025 - 03:22 AM
To install the ABH Manufacturing Inc PTR105SC Template with Swing Clear Hinges, please follow the steps below:
1. Use the transfer case housing as a drilling template. Align the template with the desired location on the door frame and mark the drilling points.
2. Ensure that only stranded wires are employed for the installation.
3. If using a spring conduit, make sure it fits wire bundles up to 5/16" thick. Take care when inserting wires through this device.
4. The rectangular cut-out for the wires should be at least 11/16" deep.
5. This installation template is designed for wood frames and doors.
6. It is recommended to label the wires for easy identification.
7. The size and number of wires used must comply with the National Electrical Code (NEC), NFPA, and local electrical codes.
8. Please note that this device is intended for low voltage use only, with a maximum of 30 VAC, 42.5 VDC, and 10 watts.
For further assistance or more detailed instructions, you can refer to the ABH Manufacturing Inc PTR105SC Template with Swing Clear Hinges Installation Guide provided by the manufacturer. You can also contact ABH Manufacturing Inc directly through their website at www.abhmfg.com or via email at abhinfo@abhmfg.com.
Add New Comment